show status lldp

LLDPのステータスを参照する

コマンドの書式

show status lldp

出力例:LLDPが無効化されている場合

lldp service is not enabled.

出力例:LLDPが有効化されている場合

-------------------------------------------------------------------------------
Self:
-------------------------------------------------------------------------------
Chassis:
  ChassisID:    mac 00:e0:4d:00:00:01
  SysName:      SA
  SysDescr:     SA-W1 Ver. 3.71 (Release)

  MgmtIP:       10.0.0.1
  MgmtIP:       2001:db8::1
  Capability:   Router, on
  Capability:   Wlan, off
-------------------------------------------------------------------------------
 
-------------------------------------------------------------------------------
Neighbors:
-------------------------------------------------------------------------------
Interface:    ge0, Time: 1 day, 00:00:25
  Chassis:
    ChassisID:    mac 02:00:00:00:db:00
    SysDescr:     Ubuntu 17.04 Linux 4.10.0-42-generic #46-Ubuntu SMP Mon Dec 4 14:38:01 UTC 2017 x86_64
    MgmtIP:       10.0.0.2
    MgmtIP:       2001:db8::2
    Capability:   Bridge, on
    Capability:   Router, on
    Capability:   Wlan, off
    Capability:   Station, off
  Port:
    PortID:       mac 02:00:00:00:db:00
    PortDescr:    vmnic0
    TTL:          120
    PMD autoneg:  supported: no, enabled: no
      MAU oper type: 10GigBaseCX4 - X copper over 8 pair 100-Ohm balanced cable
-------------------------------------------------------------------------------
Interface:    ge1, Time: 0 day, 00:13:50
  Chassis:
    ChassisID:    mac 00:00:5e:00:00:03
    SysName:      Switch
    SysDescr:     Cisco IOS Software, C2960 Software (C2960-LANBASEK9-M), Version 12.2(52)SE, RELEASE SOFTWARE (fc3)
                  Copyright (c) 1986-2009 by Cisco Systems, Inc.
                  Compiled Fri 25-Sep-09 08:49 by sasyamal
    MgmtIP:       192.168.0.3
    Capability:   Bridge, on
  Port:
    PortID:       ifname Fa0/9
    PortDescr:    FastEthernet0/9
    TTL:          120
    PMD autoneg:  supported: yes, enabled: yes
      Adv:          10Base-T, HD: yes, FD: yes
      Adv:          100Base-TX, HD: yes, FD: yes
      MAU oper type: 100BaseTXFD - 2 pair category 5 UTP, full duplex mode
  VLAN:         1, pvid: yes
-------------------------------------------------------------------------------
Interface:    ge1, Time: 0 day, 00:18:44
  Chassis:    
    ChassisID:    mac 00:00:5e:00:00:04
    SysDescr:     Juniper Networks, Inc. ex2200-48t-4g , version 10.4R5.5 Build date: 2011-06-14 02:16:29 UTC
    MgmtIP:       192.168.0.4
    Capability:   Bridge, on
    Capability:   Router, on
  Port:       
    PortID:       local 582
    PortDescr:    ge-0/0/30.0
    TTL:          120
    MFS:          1514
    PMD autoneg:  supported: yes, enabled: yes
      Adv:          10Base-T, HD: no, FD: yes
      Adv:          100Base-TX, HD: yes, FD: no
      Adv:          1000Base-X, HD: no, FD: yes
      Adv:          1000Base-T, HD: yes, FD: no
      MAU oper type: unknown
  VLAN:         900, pvid: yes vlan900
  Unknown TLVs:
    TLV:          OUI: 00,90,69, SubType: 1, Len: 12 43,55,30,32,31,34,32,33,30,37,36,31
-------------------------------------------------------------------------------

説明

  • 送受信したLLDPフレームに含まれる自身および隣接機器のTLVの値を表示します。